Systems Engineering and Electronics ›› 2021, Vol. 43 ›› Issue (10): 3000-3007.doi: 10.12305/j.issn.1001-506X.2021.10.36

• Communications and Networks • Previous Articles     Next Articles

Design and analysis of multi-carriers PSWFs-CPM joint modulation signal

Dawei YANG1,2,*, Hongxing WANG1, Lei ZHANG1, Chuanhui LIU1, Jiafang KANG1   

  1. 1. Naval Aviation University, Yantai 264001, China
    2. Unit 91349 of the PLA, Dalian 116041, China
  • Received:2020-09-18 Online:2021-10-01 Published:2021-11-04
  • Contact: Dawei YANG

Abstract:

Continuous phase modulation (CPM) signal has the advantages of constant envelope characteristics, higher power efficiency, etc., and the multi-carries modulation and demodulation system based on the prolate spheroidal wave functions (PSWFs) signal has high spectral efficiency. Combining CPM technology and multi-carriers modulation method based on PSWFs signal, a signal model of multi-carriers modulation based on PSWFs with CPM (MCM-PSWFs-CPM) model is proposed. The power spectral density (PSD) characteristics, peak to average power ratio (PAPR), and bit error ratio (BER) performance of the signal are analyzed. The simulation results show that compared with the existing PSWFs-based multi-carriers modulation and demodulation system, the out-of-band attenuation of the signal power spectrum obtained by this model relatively faster, when the number of carriers is 64 and the complementary cumulative distribution function (CCDF) is 10-3, the PAPR can be effectively reduced by about 2.70 dB, using multi-symbol detection (MSD) method can obtain better demodulation gain, and as the number of symbols increases, the detection performance is better, but the detection complexity will increase accordingly.

Key words: prolate spheroidal wave functions, continuous phase modulation, joint modulation, peak to average power ratio (PAPR)

CLC Number: 

[an error occurred while processing this directive]