系统工程与电子技术 ›› 2021, Vol. 43 ›› Issue (12): 3709-3715.doi: 10.12305/j.issn.1001-506X.2021.12.35

• 通信与网络 • 上一篇    下一篇

基于频域互相关序列与峰值检测的空频分组码盲识别算法

闫文君1, 张聿远1,*, 凌青1, 于柯远2, 谭凯文1, 刘恒燕1   

  1. 1. 海军航空大学航空作战勤务学院, 山东 烟台 264001
    2. 中国人民解放军92853部队, 辽宁 兴城 125100
  • 收稿日期:2021-03-12 出版日期:2021-11-24 发布日期:2021-11-30
  • 通讯作者: 张聿远
  • 作者简介:闫文君(1986—), 男, 副教授, 博士, 主要研究方向为MIMO技术、通信信号处理|张聿远(1997—), 男, 硕士研究生, 主要研究方向为MIMO技术、智能信号处理|凌青(1987—), 女, 副教授, 博士, 主要研究方向为MIMO技术、通信信号处理|于柯远(1992—), 男, 工程师, 博士, 主要研究方向为信号处理新技术|谭凯文(1998—), 男, 硕士研究生, 主要研究方向为雷达辐射源识别|刘恒燕(1994—), 女, 博士研究生, 主要研究方向为装备仿真与虚拟现实、通信与信息系统
  • 基金资助:
    国家自然科学基金重大研究计划(91538201);泰山学者工程专项经费(Ts201511020)

Blind recognition algorithm of space frequency block codes based on frequency domain cross correlation sequence and peak detection

Wenjun YAN1, Yuyuan ZHANG1,*, Qing LING1, Keyuan YU2, Kaiwen TAN1, Hengyan LIU1   

  1. 1. Academy of Aeronautical Operations Service, Naval Aeronautical University, Yantai 264001, China
    2. Unit 92853 of the PLA, Xingcheng 125100, China
  • Received:2021-03-12 Online:2021-11-24 Published:2021-11-30
  • Contact: Yuyuan ZHANG

摘要:

针对复杂电磁环境和非协作通信条件下空频分组码(space-frequency block codes, SFBC)信号识别困难、对先验信息要求高的问题, 提出一种基于频域互相关序列与峰值检测的SFBC盲识别方法。首先,通过分析SFBC信号的编码特点, 计算得到发送端的互相关函数。然后,考虑频率选择信道、多径传播和噪声的影响, 推导了接收信号的互相关函数, 并对其进行傅里叶变换得到频域互相关序列。最后,根据频域互相关序列检测其峰值位置识别发射端编码方式。推导和实验结果表明, 该算法在低信噪比下的识别性能较好, 并且对时间偏差和频率偏差等情况的适应性较强, 在复杂电磁环境下具有较好的识别性能, 能够应用在认知无线电和频谱检测等场合。该算法不需要知道信道和噪声的先验信息、正交频分复用(orthogonal frequency division multiplexing, OFDM)块大小以及接收端和发射端的同步信息, 非常适合于电子侦察等非协作通信场合。

关键词: 空频分组码, 互相关序列, 峰值检测, 非协作通信, 信号盲识别

Abstract:

In order to solve the problems of difficult recognition of space-frequency block codes (SFBC) and high requirement of prior information in complex electromagnetic environment and non-cooperative communication, a blind recognition method of SFBC based on frequency cross-correlation sequence and peak detection is proposed. Firstly, by analyzing the coding characteristics of SFBC signals, the cross-correlation function of transmitter is calculated. Then, considering the influence of frequency selective channel, multipath propagation and noise, the cross-correlation function of the received signal is derived, and the frequency domain cross-correlation sequence is obtained by Fourier transform. Finally, based on the frequency domain cross-correlation sequence, the peak position is detected to identify the coding mode of the transmitter. The derivation and experimental results show that the algorithm has good recognition performance at low signal to noise ratio (SNR), strong adaptability to time deviation and frequency deviation, and has good recognition performance in complex electromagnetic environment. It can be applied to cognitive radio and spectrum detection. The algorithm does not need to know the priori information of channel and noise, the size of orthogonal frequency division multiplexing (OFDM) block and the synchronization information of receiver and transmitter, so it is very suitable for non-cooperative communication occasions such as electronic reconnaissance.

Key words: space-frequency block code (SFBC), cross-correlation sequence, peak detection, non-cooperative communication, blind signal recognition

中图分类号: