系统工程与电子技术 ›› 2025, Vol. 47 ›› Issue (4): 1246-1254.doi: 10.12305/j.issn.1001-506X.2025.04.21

• 系统工程 • 上一篇    下一篇

基于IAHP-CRITIC-MARCOS的多种类目标威胁评估

杨天建1, 王星1, 程嗣怡1, 陈游1,*, 张曦1, 张志恒2   

  1. 1. 空军工程大学航空工程学院, 陕西 西安 710038
    2. 中国人民解放军 93161 部队, 辽宁 沈阳 110015
  • 收稿日期:2024-04-10 出版日期:2025-04-25 发布日期:2025-05-28
  • 通讯作者: 陈游
  • 作者简介:杨天建(2001—), 男, 博士研究生, 主要研究方向为电子对抗原理与技术
    王星(1965—), 男, 教授, 博士, 主要研究方向为电子对抗原理与技术
    程嗣怡(1980—), 男, 教授, 博士, 主要研究方向为电子对抗原理与技术
    陈游(1983—), 男, 副教授, 博士, 主要研究方向为电子对抗原理与技术
    张曦(1979—), 男, 副教授, 博士, 主要研究方向为电子对抗原理与技术
    张志恒(1982—), 男, 工程师, 硕士, 主要研究方向为电子对抗作战指挥

Multi-type target threat evaluation based on IAHP-CRITIC-MARCOS

Tianjian YANG1, Xing WANG1, Siyi CHENG1, You CHEN1,*, Xi ZHANG1, Zhiheng ZHANG2   

  1. 1. Aviation Engineering College, Air Force Engineering University, Xi'an 710038, China
    2. Unit 93161 of the PLA, Shenyang 110015, China
  • Received:2024-04-10 Online:2025-04-25 Published:2025-05-28
  • Contact: You CHEN

摘要:

针对传统的目标威胁评估往往只面向单种类目标的问题, 从体系角度构建目标威胁评估指标体系, 并提出一种基于区间层次分析(interval analytic hierarchy process, IAHP)法-指标相关性的权重确定(criteria importance through inter-criteria correlation, CRITIC)法-折衷解备选方案排序(measurement alternatives and ranking according to compromise solution, MARCOS)法的体系目标威胁评估方法。首先, 利用IAHP和CRITIC分别计算出各项指标的主、客观权重。在此基础上, 利用最小信息鉴别原理进行组合赋权, 以此避免单独赋权的缺陷。然后, 基于MARCOS计算各个目标威胁值, 并进行威胁排序。最后, 通过仿真实例对比分析采用灰色关联分析(grey relational analysis, GRA)、逼近理想解排序法(technique for order preference by similarity to ideal solution, TOPSIS)、GRA-TOPSIS以及MARCOS得出的目标威胁排序结果, 验证所提方法的科学性和有效性。

关键词: 目标威胁评估, 指标体系, 组合赋权, 基于折衷解的备选方案排序法

Abstract:

For the problem that traditional target threat evaluation is usually oriented only to a single type of target, a target threat evaluation index system is constructed from a system perspective and a system target threat evaluation method based on interval analytic hierarchy process-criteria importance through inter-criteria correlation-measurement alternatives and ranking according to compromise solution (IAHP-CRITIC-MARCOS) is proposed. Firstly, the IAHP and the CRITIC method are utilized to determine the subjective and objective weights of each criterion respectively. Secondly, based on the principle of minimal information identification, these weights are integrated to form a comprehensive weighting system, aimed at overcoming the limitations inherent to relying solely on single-weight methodologies. Then, the MARCOS is used to calculate threat value of each target and perform threat ranking. Finally, the results of target threat ranking using grey relational analysis (GRA), technique for order preference by similarity to ideal solution (TOPSIS), GRA-TOPSIS, and MARCOS are compared and analyzed, and the scientificity and effectiveness of the proposed method are validated.

Key words: target threat evaluation, criteria system, comprehensive weighting, measurement alternatives and ranking according to compromise solution (MARCOS)

中图分类号: