系统工程与电子技术

• 电子技术 • 上一篇    下一篇

WGS-84坐标系下机载单站PDR/DFR无源定位滤波算法

吴卫华1,江晶2,范雄华1,袁俊泉3   

  1. 1. 空军预警学院研究生管理大队, 湖北 武汉 430019;2. 空军预警学院空天预警实验室, 湖北 武汉 430019;3. 空军预警学院空天预警装备系, 湖北 武汉 430019
  • 出版日期:2014-01-20 发布日期:2010-01-03

Filtering algorithms of passive location based on PDR/DFR by single airborne platform in WGS-84

WU Wei-hua1,JIANG Jing2,FAN Xiong-hua1,YUAN Jun-quan3   

  1. 1. Department of Graduate Management, Air Force Early Warning Academy, Wuhan 430019, China;
    2. Aerospace Early Warning Laboratory, Air Force Early Warning Academy, Wuhan 430019, China;
    3. Department of Air/Spacebased Early Warning Surveillance Equipment, Air Force Early Warning Academy, Wuhan 430019, China
  • Online:2014-01-20 Published:2010-01-03

摘要:

在WGS-84坐标系下实现机载单站对固定辐射源高精度无源定位有着重要的应用价值。提出WGS-84坐标系下机载单站相位差变化率/多普勒变化率(PDR/DFR)无源定位滤波算法。首先导出PDR/DFR相对定位公式,经坐标变换实现单次观测的绝对定位;分别采用一阶Taylor近似分析法和不敏变换(unscented transformation, UT)推导滤波中需要的转换量测及其协方差,实现多帧量测滤波,进一步提高定位精度,且后者克服了前者不能对非线性转换量测进行偏差补偿以及协方差一致性较差的不足。仿真结果表明,该方法能实现三维高精度的无源定位,有望用于工程实际。

Abstract:

For an important application value to highprecise passive location for stationary emitter by single airborne platform in world geodetic system-84 (WGS-84), the filtering algorithms of passive location base on phase difference rate of changing and Doppler frequency rate of changing (PDR/DFR) by single airborne platform in WGS-84 are proposed. Relative positioning formula base on PDR/DFR is derived firstly, and then absolute positioning is realized through coordinate transformation; Employing firstorder Taylor approximation and unscented transformation (UT) respectively, converted measurements and their covariance are derived which are required for filtering multiframe measurements in order to improve the positioning accuracy, and the latter overcomes the former’s weaknesses that the bias compensation cannot be realized for nonlinear transformation and covariance is less consistent. Simulation results indicate that the presion of threedimensional passive location is high, and it is expected to be used in engineering practice.