Journal of Systems Engineering and Electronics ›› 2011, Vol. 33 ›› Issue (5): 996-.doi: 10.3969/j.issn.1001-506X.2011.05.07

• 电子技术 • 上一篇    下一篇

赋形卡氏天线主面变形的副面实时补偿

冷国俊1,王伟1, 段宝岩1,李小平2   

  1. 1. 西安电子科技大学电子装备结构设计教育部重点实验室, 陕西 西安 710071;
    2. 中国电子科技集团公司第三十九研究所, 陕西 西安 710065
  • 出版日期:2011-05-25 发布日期:2010-01-03

Subreflector realtime compensation for main reflectordeformation of shaped Cassegrain antenna

LENG Guo-jun1, WANG Wei1, DUAN Bao-yan1, LI Xiao-ping2   

  1. 1. Key Laboratory of Electronic Equipment Structure Design of Ministry of Education, Xidian University, Xi’an 710071, China;
    2. 39th Institute of China Electronics Technology Group Corporation, Xi’an 710065, China
  • Online:2011-05-25 Published:2010-01-03

摘要:

针对赋形卡氏天线主面变形导致电性能变差的情况,提出了一种通过实时调整副面位置对其进行补偿的方法。根据最小二乘法对赋形主面的母线离散数据进行分段抛物线拟合,用得到的一组标准抛物环面对变形后的主面进行最佳吻合,同时限定各抛物环面满足同焦轴约束。通过优化计算得出主面吻合参数,再根据主副面的匹配关系,计算副面的空间位置调整参数。将各工况下的副面调整参数存入数据库,实时调用以补偿主面变形。对某64 m天线进行了案例验证,得到了满意的结果。

Abstract:

On the degradation of electrical performance of large shaped Cassegrain antennas by the main reflector deformation, a method for compensation by the moving subreflector is presented. A group of bestfit paraboloids are found by leastsquare fitting the theoretical discrete data. The group of paraboloids are used to fit the deformed main reflector, with the constraint of all these focuses being in line. The bestfit parameters are optimized and the adjustments of subreflector are derived with the ratio of main reflector and subreflector. The adjustments at various attitudes are saved in a lookup table to realtime compensate for main reflector deformation. From the experimental verification on a 64 m reflector antenna, satisfactory results are obtained.