Systems Engineering and Electronics ›› 2024, Vol. 46 ›› Issue (5): 1544-1554.doi: 10.12305/j.issn.1001-506X.2024.05.09

• Sensors and Signal Processing • Previous Articles    

Analysis of the influence of non uniform interrupted sampling repeater jamming on intra-pulse agile radar

Zongzheng SUN1, Zhixing LIU1, Guoyao XIAO1, Hanting QI2, Yinghui QUAN1,*   

  1. 1. School of Electronic Engineering, Xidian University, Xi'an 710071, China
    2. Beijing Institute of Radio Measurement, Beijing 100854, China
  • Received:2022-11-24 Online:2024-04-30 Published:2024-04-30
  • Contact: Yinghui QUAN

Abstract:

Intra-pulse frequency agile radar can effectively suppress interrupted sampling repeater jamming by its own "active" anti-jamming characteristics, taking advantage of the discontinuity and periodicity of traditional interrupted sampling repeater jamming, and combining with anti-jamming algorithms. In order to improve the jamming efficiency of the jammer against the intra-pulse frequency agile radar, this paper proposes to use the non-uniform interrupted sampling repeater jamming to jam the intra-pulse frequency agile radar. First, the intercepted intra-pulse frequency agile radar signal is estimated by time-frequency ridge extraction and wavelet transform to obtain the sub-pulse width, and then the non-uniform interrupted sampling repeater jamming is constructed according to the sub-pulse width constraint jamming parameters. Theoretical analysis and results show that it is difficult to suppress interference in intra-pulse frequency agility radar in time and frequency domain through non-uniform interrupted sampling repeater, which greatly improves the jamming ability of jammer.

Key words: electronic counter, intra-pulse frequency agility, time-frequency ridge line, wavelet transform, non-uniform interrupted sampling repeater jamming, parameters of jamming

CLC Number: 

[an error occurred while processing this directive]