系统工程与电子技术

• 传感器与信号处理 • 上一篇    下一篇

基于杂波区分度参数的舰船检测方法

焦智灏1,2, 杨健1, 叶春茂3, 宋建社4   

  1. 1. 清华大学电子工程系, 北京 100084; 2. 工业和信息化部信息中心, 北京 100846;
    3. 北京无线电测量研究所, 北京 100854; 4. 解放军第二炮兵工程大学, 陕西 西安 710025
  • 出版日期:2014-08-22 发布日期:2010-01-03

Ship detection method based on distinction parameter between areas of targets and clutters

JIAO Zhi-hao1,2, YANG Jian1, YE Chun-mao3, SONG Jian-she4   

  1. 1. Department of Electronic Engineering, Tsinghua University, Beijing 100084, China; 
    2. Information Center, Ministry of Industry and Information Technology, Beijing 100846, China; 
    3. Beijing Institute of Radio Measurement, Beijing 100854, China; 
    4. The Second Artillery Engineering College, Xi’an 710025, China
  • Online:2014-08-22 Published:2010-01-03

摘要:

针对极化合成孔径雷达(polarimetric synthetic aperture radar, PolSAR)的目标检测,提出了一个杂波区分度参数。通过构造一个包含了部分杂波像素及目标区域像素的集合,提取的杂波区分度参数衡量了该集合的均匀性,从而反映出目标区域与杂波分布的区分度。对于全极化数据,通过将3个极化通道的杂波区分度参数相乘,提出了用于舰船检测的检测量,并进行目标检测的方法。实验结果表明,所提方法实现了很好的目标检测性能。

Abstract:

For target detection based on the polarimetric synthetic aperture radar(PolSAR), a distinction parameter between areas of targets and clutters is proposed. The parameter describes the uniformity of a set composed of pixels from areas of targets and clutters, so as to reflect the distinction between distributions of targets and clutters. For PolSAR data, a new detector is proposed, which is the product of multiply distinction parameters from three polarimetric channels. A ship detection method based on the detector is also developed, and experimental results demonstrate the efficiency of the proposed method.